Здравствуйте!
Помогите решить следующую проблему – не устанавливается тоннель между DFL-200 и Cisco PIX 515.
IKE устанавливается, а вот IPSec почемуто не работает Конфиг для Cisco:
: Saved
: Written by enable_15 at 09:13:04.700 UTC Thu Mar 1 2007
!
PIX Version 7.2(2)
!
hostname pixfirewall
domain-name office.ru
enable password * encrypted
names
!
interface Ethernet0
nameif outside
security-level 0
ip address A.A.A.A 255.255.255.0
!
interface Ethernet1
nameif inside
security-level 100
ip address 192.168.21.1 255.255.255.0
!
interface Ethernet2
shutdown
no nameif
no security-level
no ip address
!
passwd * encrypted
ftp mode passive
dns server-group DefaultDNS
domain-name office.ru
access-list outside_20_cryptomap extended permit ip 192.168.21.0 255.255.255.0 192.168.20.0 255.255.255.0
access-list outside_nat0_outbound extended permit ip 192.168.21.0 255.255.255.0 192.168.20.0 255.255.255.0
access-list 101 extended permit ip 192.168.21.0 255.255.255.0 192.168.20.0 255.255.255.0
access-list 101 extended deny ip any any
pager lines 24
logging asdm informational
mtu inside 1500
mtu outside 1500
icmp unreachable rate-limit 1 burst-size 1
asdm image flash:/asdm
asdm history enable
arp timeout 14400
nat (inside) 0 0.0.0.0 0.0.0.0
nat (outside) 0 access-list outside_nat0_outbound
route outside 0.0.0.0 0.0.0.0 B.B.B.B 1
timeout xlate 3:00:00
timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 icmp 0:00:02
timeout sunrpc 0:10:00 h323 0:05:00 h225 1:00:00 mgcp 0:05:00 mgcp-pat 0:05:00
timeout sip 0:30:00 sip_media 0:02:00 sip-invite 0:03:00 sip-disconnect 0:02:00
timeout uauth 0:05:00 absolute
aaa-server RADIUS protocol radius
aaa-server TASACS+ protocol tacacs+
no eou allow clientless
http server enable
http 192.168.21.0 255.255.255.0 inside
no snmp-server location
no snmp-server contact
snmp-server enable traps snmp authentication linkup linkdown coldstart
crypto ipsec transform-set ESP-DES-MD5 esp-des esp-md5-hmac
crypto ipsec transform-set MySet esp-des esp-sha-hmac
crypto ipsec transform-set ESP-DES-SHA esp-des esp-sha-hmac
crypto map outside_map 20 match address outside_20_cryptomap
crypto map outside_map 20 set peer B.B.B.B
crypto map outside_map 20 set transform-set MySet ESP-DES-SHA
crypto map outside_map interface outside
crypto isakmp enable inside
crypto isakmp enable outside
crypto isakmp policy 10
authentication pre-share
encryption des
hash md5
group 2
lifetime 14400
crypto isakmp policy 30
authentication pre-share
encryption des
hash sha
group 2
lifetime 14400
tunnel-group B.B.B.B type ipsec-l2l
tunnel-group B.B.B.B ipsec-attributes
pre-shared-key 123456
chain
telnet timeout 5
ssh timeout 5
console timeout 0
dhcpd address 192.168.21.2-192.168.21.50 inside
dhcpd dns 195.14.50.1 195.14.50.21 interface inside
dhcpd enable inside
!
!
class-map inspection_default
match default-inspection-traffic
!
!
policy-map type inspect dns preset_dns_map
parameters
message-length maximum 512
policy-map global_policy
class inspection_default
inspect dns preset_dns_map
inspect ftp
inspect h323 h225
inspect h323 ras
inspect rsh
inspect rtsp
inspect esmtp
inspect sqlnet
inspect skinny
inspect sunrpc
inspect xdmcp
inspect sip
inspect netbios
inspect tftp
!
service-policy global_policy global
prompt hostname context
Cryptochecksum:2179bf7db366f592ecc9bc1edd0395aa
: end
Конфиг для длинки:
BASE
LAN: 192.168.20.1
WAN: B.B.B.B
Gateway: A.A.A.A
VPN
Name: Cisco
Local Net: 192.168.20.0/24
Authentication
Pre Shared Key: 123456
LanToLan tunnel:
Remote net: 192.168.21.0 - 192.168.21.254
Remote gateway: A.A.A.A
ADVANCED:
MTU: 1500
IKE mode: main
IKE DH group: 2 – modp 1024-bit
NAT traversal: On if supported and needed (NAT detected between gateways)
Keepaives: no keepalives
IKE proposal list:
DES SHA-1 14400
DES MD5 14400
IPSec proposal list:
DES SHA-1 28800
DES MD5 28800
Длинка в логах пишет следующее:
[2007-03-02 12:06:29] <6>EFW: IPSEC: prio=1 Phase-2 [initiator] for ipv4(icmp:0,[0..3]=192.168.20.2) and ipv4(icmp:0,[0..3]=192.168.21.1) failed; Aborted notification.
[2007-03-02 12:06:29] <4>EFW: IPSEC: prio=3 Authenticated notify "Responder lifetime notification" from A.A.A.A:500 for protocol ISAKMP spi[0..16]=f3 16 65 33 f4 43 9d 44 0b dd af e3 44 84 88 70
[2007-03-02 12:06:29] <6>EFW: IPSEC: prio=1 Phase-1 [initiator] between ipv4(udp:500,[0..3]=B.B.B.B) and ipv4(udp:500,[0..3]=A.A.A.A) done.
Хочу узнать почему не коннектится?
Время в группах вроде правильно стоит. Может в аксесс листе циски что не так?
Помогите плиз.
Еще вот Дебаг IPSEC
IPSEC: Received a PFKey message from IKE
IPSEC: Parsing PFKey GETSPI message
IPSEC: Creating IPsec SA
IPSEC: Getting the inbound SPI
IPSEC: New embryonic SA created @ 0x019D8608,
SCB: 0x01980670,
Direction: inbound
SPI : 0x423C6783
Session ID: 0x0000010B
VPIF num : 0x00000002
Tunnel type: l2l
Protocol : esp
Lifetime : 240 seconds
IPSEC: Received a PFKey message from IKE
IPSEC: Parsing PFKey GETSPI message
IPSEC: Creating IPsec SA
IPSEC: Getting the inbound SPI
IPSEC: New embryonic SA created @ 0x027CDAD0,
SCB: 0x02815640,
Direction: inbound
SPI : 0x08BF8B53
Session ID: 0x0000010B
VPIF num : 0x00000002
Tunnel type: l2l
Protocol : esp
Lifetime : 240 seconds
И через некоторое время:
IPSEC: Received a PFKey message from IKE
IPSEC: Destroy current inbound SPI: 0x423C6783
IPSEC: Received a PFKey message from IKE
IPSEC: Destroy current inbound SPI: 0x08BF8B53
PS: да, и еще проблема – пинги от длинки до циски ходят, а наоборот нет. Где галку в циске поставить?
